Skip to main content
FW version: Stable

Getting started

tip
  • The display works out of the box with the default settings.
  • It is necesary to have a working and connected controller with LYNX to use the display.

How to setup the display​

  • Most important thing is to have a working controller with LYNX firmware
  • Connect the display with the controller using the CAN
    • Check if you have proper CAN termination
  • Check if CAN speed is the same for both devices
    • Both devices are standardly configured to 1000 kbps
  • Connect GND, POWER, and KEY pins from the display to the same pins on the controller
  • Power the vehicle on by pressing the BTN1 button on the display (the red one)

Buttons functions​

This is the default action for buttons on display.

BTN1​

  • Short press: cycle through main screens
  • Long press: go back one level in menu
  • Extra long press - turn the display (and the vehicle) off

BTN2​

  • Action button for main screen (not used on all the screens)

BTN3​

  • Short press: cycle through the sub-screens

BTN4 - external button​

  • Short press: change map
  • On the stopwatch screen: start the time count (map change function is moved to BTN3)

BTN2 + BTN3​

  • long-press both these buttons: enter the main menu