Product overview
VDS1 Display
VDS1 Display is an accessory for siliXcon brushless motor controllers, designed to operate with the same low-voltage DC power sources as the controllers. These displays are fully compatible with all siliXcon motor controllers, ensuring seamless integration and communication. Constructed from aluminum, they offer high durability and resistance to corrosion, making them suitable for harsh environments and ensuring a long lifespan. The compact, minimalist design of siliXcon displays facilitates easy installation and use in confined spaces, while also contributing to a modern and clean aesthetic for the overall system.
The display is depicted below with the marking of its main parts.
| Position | Name |
|---|---|
| 1 | Venting hole |
| 2 | Bottom mounting holes |
| 3 | Signal cables |
| 4 | Top mounting holes |
| 5 | Button 1 / Powering |
| 6 | Button 2 |
| 7 | Button 3 |
Powering, communication and signals are connected via the signal cables - 3. The display is turned ON/OFF by Button 1 - 5 and is controlled by three buttons - 5, 6 and 7. Pressure equalization is done trhough the venting membrane - 1. The display can be attached by the bottom mounting holes - 2 or the top mounting holes - 4.
Product identification label
Each product is equipped with an identification label containing pertinent information.
| Position | Name |
|---|---|
| 1 | Maximum operating voltage |
| 2 | Country of manufacture |
| 3 | SN QR code |
| 4 | Serial number |
| 5 | Product Name |
| 6 | Order code |
Product variants
The Manufacturer Part Number (MPN) completely specifies the product type and version. When combined with the Firmware Identifier (Basename), it can serve as the ordering code. The MPN is made up of different sections, which are explained in the table below. Typically, only the standard variants are in stock.
MPN of the standard variant: VDS-felix_dx0-01E_S04-2B0
- Main PCB assembly variant
- Finish
| Power features | Connectivity | Sensors | Internal HW configuration |
|---|---|---|---|
| d - without RTC | x - USB, CAN | 0 - no sensors | 01E - Flip-flop with button, CAN terminator, Turn LED by FW |
Internal HW configuration selectable features
| Powering options | CAN terminator | Turn LED by FW | Light LED by FW |
|---|---|---|---|
| Constant on | Activated | Activated | Activated |
| Flip-flop | Deactivated | Deactivated | Deactivated |
| Flip-flop with button | |||
| Activation input |
More information about the particular configurable features can be found in this chapter
| Cable variant | HW variant |
|---|---|
| S04 | 2B0 - Aluminium back lid, holes for bafang display holder, cable gland for 2 wires. |
Accesories
Display Holders
The display is compatible with Bafang 850C display holders and this holder can be used for mounting it on handlebars.
Alternatively, below is the source data for 3D-print display holders. These can be used for prototyping.
Map Button
The display is designed to work with Lonelli waterproof push button (Ref.:071) and this can be ordered from siliXcon.
| Part name | description |
|---|---|
| Leonneli button 52 cm JST | Leonelli Ref.:071 map buton |