Skip to main content
FW version: Stable

ESCx first-run config scripts

is a collection of scripts to perform an initial setting of an ESCx controller so you can start experimenting with your motor.

How to run

These scripts are distributed within the standard SWtools package. Download and install the SWtools first and set up the connection options for your device. After installation, these scripts are located in c:\siliXcon\scripts\configuration\First_run. Double-clicking the files will start their execution.

warning

During the configuration, the motor may move or spin. Do not use it unless you are sure that the spinning motor will not cause any harm or injury.

How to use

  • 1-Motor_sensor_selection.ys will guide you through the selection of your motor position sensor.
  • 2-Motor_identification.ys will guide you through automatic motor and sensor parameter identification.